Precautions for the construction of the fence around the greenhouse

Precautions for the construction of the fence around the greenhouse

Precautions for the construction of the fence around the greenhouse:

1. Fixing method When fixing the fence around the greenhouse, use special clips to nail it on the exposed outer surface of the structure, crossbar, wall panel, etc. The fence around the greenhouse has been positioned as a whole. The benches and pillars are prone to corrosion and damage. They need to be disconnected and nailed directly in the clips. It looks relatively flat and strong. However, this fixing method can only partially work. If there is a risk incident, it is very unstable. Therefore, under normal circumstances, the cloth glue method is used. This method seems to be a bit lazy, but it is labor-intensive, and the damage to the structure is very large.

2. Installation method of the fence around the greenhouse The fence around the greenhouse should be installed in an I-shaped, triangular, and figure-eight shape, and try to install each side on the same plane to facilitate fixing in the center of the structure. When installing the fence around the greenhouse, it is necessary to determine the feasible installation orientation according to the planning drawings, the vertical vertical and horizontal orientations of the left and right. After the net is cut, it is nailed to the outside of the structure. Before installing the fence around the greenhouse, the cut fence around the greenhouse should be straightened and placed in a suitable size and orientation, and the difference between the left and right lengths should not exceed 3 meters. Use special glue to fix the fence around the greenhouse with cloth glue, do not fix it with nails. Generally, the fence around the greenhouse should first fix the skeleton inside the steel structure as the structural foundation, and then fix each group of rods. Regarding the fire-resistant crossbar, it is also necessary to ensure the size recommended by the manufacturer, and first use the technical perforation method to fix it.

3. The quality of the clips Under normal circumstances, the thickness is the same as that of the same number of cloth plastic greenhouse fences. The fixing materials of the above three kinds of greenhouse fences should be steel wire expansion bolts, but the methods are different. Generally speaking, the expansion bolt is twisted into the iron wheel according to the number of pounds to fix, and the shuttle wire required to be used is a little thinner than the iron wheel with the same thread diameter. The pre-coated clips are generally based on specific lines, and the clips are deformed accordingly through physical methods, and are fixed to a certain position through the mold.

4. The choice of adhesive The adhesive is the same as that of yellow sand, divided into outer layer adhesive and inner layer adhesive. In general, the adhesives are imported industrial-grade abs hard plastics.