Measurements should be carried out before the greenhouse construction to effectively reduce installation errors

Measurements should be carried out before the greenhouse construction to effectively reduce installation errors

Before the construction of the greenhouse, a steel tape measure with a length of more than 50 meters can be used for measurement, which can effectively reduce the installation error. In addition to burying the embedded parts of the arch frame, it is also necessary to bury the hooks of the lamination line, mainly to facilitate the installation of the lamination line in the future.

For the lamination line at the top of the rear wall, it is made of steel bars, or it is used by bending steel bars into rings and hooks. If the height is a hook ring with a height of 25 cm, the height of the exposed corner should be About eight centimeters, the hook of the lamination line should also be set in the arch, and the parallel distance between the outer sides of the embedded parts should be kept at 5-8 centimeters.

The hook ring in the lamination line is directly installed in the middle of the embedded parts in the two arches. For each installation, one needs to be vacated. There is a door on one side of the gable. If you need to build a workshop, yes It is built at one end of the greenhouse, but the height of the entire workshop should not be too high to avoid blocking the sun.

At the front corner of the greenhouse, a wall skirt of about 25 cm can be built, and then there are embedded parts. The main function of the wall skirt is to block the wind, fix the arch and waterproof it.

The embedded parts of the arch frame in the wall skirt can correspond to the embedded parts of the arch frame on the back wall. Therefore, the wall skirt also needs to be provided with lamination line hooks. Under normal circumstances, they will be directly set on the outside of the wall skirt. The position corresponds to the lamination line hook ring of the rear wall. After the entire arch is completely installed, the position of the wall skirt and the rear wall can be plastered. Remember that the welding joint can be directly It should be plastered on the inside, and the order of plastering should be to smear the slope to the outside, which is more conducive to drainage.