For users who construct greenhouses, they are more concerned about the installation steps and nodes of the greenhouse, because this relates to whether the installation time and payment nodes of the greenhouse are reasonable.
The installation steps of the greenhouse are all from top to bottom. In the industry, it is generally divided into foundation production and installation, greenhouse skeleton installation and production, internal and external shading system installation, greenhouse aluminum profile installation, roof covering material installation, and surrounding coverage. Installation of materials, installation of side openings on top and side openings, power distribution and drive system debugging.
1. Foundation production and installation
The foundation of the greenhouse is generally divided into the independent foundation in the middle and the installation of the surrounding ring beams. These include the ultra-flat fixing of the embedded parts. After these tasks are completed, the skeleton material can enter the site for installation work. After the framework of the greenhouse is installed, the construction of the retaining walls around the greenhouse can be carried out simultaneously.
2. Installation of greenhouse skeleton
The installation of the greenhouse frame material includes the installation of the columns, the installation of the beams, and the installation of the sink brackets between the installations of the columns, and then the installation of the sink (the gable beam or the arch connector is installed on the ground before the sink is installed), Installation of herringbone beams or levers, installation of external shading skeletons. All the above items are installed, the installation of the skeleton is considered complete.
3. the installation of internal and external shading system
The installation of the sunshade inside and outside the greenhouse includes the installation of hanging wheels, driving cards, driving edges, curtain support lines, positioning cards, positioning springs, and sunshade nets. The problem in the greenhouse is also the driving part of the sunshade system, gear spacing, driving positioning stroke, etc. If the installer is not skilled enough, the later maintenance and repair will be very troublesome.
4. the installation of greenhouse aluminum profiles
The installation of the greenhouse aluminum profile includes the installation of the wall aluminum profile and the installation of the top aluminum profile. If it is a thin-film greenhouse, then only the fixed card film slot is installed on the top and the surroundings, and there is no installation of aluminum profiles.
5. Installation of covering materials on the top and surrounding sides
The patterned greenhouse is generally covered with double-layer hollow glass, and the top is covered with solar panels or single-layer tempered glass.
6. Installation of top and side windows
7. Installation and commissioning of power distribution and drive stroke system
The power distribution system refers to the power distribution of the entire greenhouse motor, and it is also the end of the greenhouse work. The debugging of the driving stroke refers to the debugging and fixing of the motor stroke limit of the greenhouse. This is also very important, and it is also a place where problems are prone to occur.
